Written and Copyright @ cacdesigns 2010 This is my own
creation; any similarities to other tutorials are purely
coincidental and unintentional.
Move the hand along each step you are on so
you don't lose track:
Just left click on the hand and drag
to where your at:
1. New image 500 x 300 transpartent.
2. Make your paintbrush settings the same as mine below.
3. Set your foreground to: #004000
4. Start your
pixel center of your working image. Note if you don't see a
number for pixels in the examples it means either 1 pixel or 2 you
can tell my the length of the actuayl line.
the starting points to finish. I did my outlinesin red
so that you can see the difference.
This is what mine looks like now:
Save it as a pspimage of a png save so that you can use it
1. Use your magic wand and
click inside of each circle. My example will follow.
If you find that the selections go beyond the border of what you
made then that means the pixels did not connect so use your
color and find were its not connected and connect the lines.
What it will look like after your pixels are connected:
Now that all your circles are selected change your foreground to
#718863. After your done go to adjust/add remove noise/add
noise and make your settings like mine below:
This is our finished vine:
Part 5 - Flower.
1. Start new image 100 x 100.
Change your brush setting from 3 to 1 and your background color
to #8e048c below are the steps for your flower:
Left side of flower.
Once your flower is completed right click
and duplicate it.
image/mirror. Match up the sides so its a complete flower this
is what you should have now:
Once your flower is complete merge it visible. Save it as
a png or pspimage save so you can use it over and over again and
color it differently.
Part 6 - Coloring
1. Using your magic wand click
in the center of your flower and flood fill with: #c385ae
2. Selections/select none.
3. Now change your
foreground to: #f7d6ef and make a square outline in the center
4. Change your
foreground color to : #fcaaf3.
5. Using your magic wand
click in each petal and flood fill with your color this is what mine
looks like now:
6. While it is still selected go to adjust/add remove
noise/add noise and use my settings below:
7. Selections/select none.
8. Right click and copy. Go to your vine and paste as a
new image. This is were the fun stuff comes into play.
Continue duplicating and moving your flowers around your vine.
9. When your finished save your vine as a png to turn in for
credit. This is what mine looks like: